PYLE PLAD413 4 Channel 2000 Watt Bridgeable Mosfet Amplifier

WOW!!! I used this as a subwoofer amp to drive two PYLE 12" 600 watt cabinets in the back of a 2001 PT CRUISER. One of the most powerful low buck amps out there!

LOW NOISE (if any)!! Doesn't get HOT! (temperature wise)!
SUPER flexable-has many available wiring options-4 channel, three channel, two channel and MONO BRIDGED!

REMOTE SUBWOOFER DASH CONTROL is super handy & esy to install!!
Full selection of adjustment pots and on-board CROSSOVER make this another PYLE "BIG BANG FOR THE BUCK"

Get this amp-you can't go wrong-
but please get it from AMAZON-nice people, fast shipping-low PRICES!!!

I can say one thing!If u want your car audio blow your branes out,this Pyle amplifier is the one of the best ways u can do that.This is crazy and this is amazing.I connected 4 speakers and 2 subwoofers and now I have the audio power much more then I even awated. bass is pure and powerfull and quality if sound is impressing.

I have no idea what those other reviews where talking about. yes I did hook this amp up and got decent performance but nothing like what they said. I have two 12 type alpine X speakers and I hooked the pyles amp to them and it wasn't as bad as I thought it would have been. I also had a alpine 450 true watt amp that I switched out and compared to the pyles. The alpine without a doubt out performed the pyles. Then I bridged the pyles and compared. The pyles did out perform the alpine....when it didn't cut off...which happened constantly until it blew. Now I have the alpine in there doing the same performence and hasn't blown. Listen to me and just buy a lower wattage, better brand amp. Don't waste your money on this piece of junk.

I have 4 diamond hex audios and 2 blaupunkts all 6" and 2 1.5" diamonds hooked to this one, and at full blast the amp gets hot but it sounds fantastic.

4 x 200W RMS @ 4 Ohms 4 x 500W MAX @ 4 Ohms 2 x 800W MAX @ 4 Ohms idged 4 x 350W RMS @ 2 Ohms Electronic Crossover Network Bass Boost Circuit idgeable at 4 Ohms 2 Ohm Stereo Stable Tri-Mode Capable Gold Plated RCA Inputs Line Outs for 1 and 2 Channel Low Pass Filter Control High Pass Filter Control Remote Bass Level Control (Included) Power and Protection LED Indicators Red Lighting Illumination Side Leg Mounting THD: <0.04%. S/N Ratio: >90dB Input Sensitivity : 100mV ~4V Channel Separation : >65dB Freq. Response : 10Hz ~ 30KHz Patent Pending Soft Turn-on/Turn-off Dimensions : 8.6-Inch(W) x 2.27-Inch(H) x 12.6-Inch(L)